Country preference? Choose the preferred country to view local content and get a better experience.
Titanium Chef Baker XL Silver KVL85.004SI
For the cannoli:300g plain flour 25g caster sugar ¼ tsp salt 30g unsalted butter, room temp120ml dry wine 2 egg yolks Vegetable oil, as needed200g dark chocolate, broken up100g pistachios, finely choppedFor the filling:500g ricotta, strained through a cheesecloth200g mascarpone 30g candied peel, finely chopped40g icing sugar, sieved1 tsp vanilla extract To finish:Icing sugar, as needed
1 - Lift the Chef Patissier XL head and fit the head shield. Fit the Dough tool to the machine and attach the Mixer bowl to the machine2 - Add the flour, sugar, and salt into the bowl. Mix on speed 1 for 30 seconds until roughly combined.3 - Add the butter, wine, and egg yolks. Mix on speed 1 for 4 minutes until a smooth dough has formed. If the dough is too sticky, add a little flour.4 - Knead on speed 1 for 30 seconds to 1 minute until the dough fully comes together. Remove the dough tool from the machine. Wrap the dough and chill in the fridge for 4 hours or overnight (this step is optional).5 - Once chilled, remove the dough from the fridge and place on a lightly floured work surface. Divide into four equal pieces.6 - Take one piece and cover the rest. Roll out the dough into a log until roughly 2 mm thick, then use a 3.5” round cutter and cut out circles. 7 - Place each cannoli tube in the middle of dough circle and roll the tube down to the bottom edge. Then, roll it back to the top edge to shape the dough, the edges should overlap slightly in the middle. 8 - Dip your finger in egg white and lightly wet the overlapped dough to seal. To strengthen and secure the shape, roll along the worktop again, keeping the dough taught so it clings to the shape of the tube. Press it together with your finger to prevent the tube from separating when frying later. 9 - Place the wrapped tubes on the prepared baking tray. Repeat the rolling and shaping process with the remaining dough.10 - Heat the oil in a large saucepan and place over a medium-high heat until the temperature reaches 176ºC.11 - Fry the cannoli in batches of 3 for 2 minutes on each side until golden brown. Carefully use tongs to roll the cannoli over in the oil, then remove from the saucepan and drain the excess oil. 12 - Place on a plate or tray lined with paper towels for 30 seconds. Use paper towels to gently remove the tubes and leave to cool completely.13 - To decorate the cannoli shells, attach the EasyWarm bowl to the machine and fit the Creaming beater. Add the dark chocolate into the and fit the splash guard.14 - Set to temp setting 7 and mix on speed 1 for about 10 minutes until the chocolate has melted. Alternatively, use the ‘chocolate melting’ pre-set if applicable.15 - Empty the melted chocolate into a small bowl and leave to cool slightly. Dip the end of each cannoli until coated and sprinkle with the chopped pistachios. Place the cannoli onto a wire rack until the chocolate has set.16 - To make the filling, attach the clean Mixer bowl to the machine and fit the Whisk tool. 17 - Add the ricotta, mascarpone, candied peel, icing sugar, and vanilla extract and mix on speed 5 for 30 seconds until combined18 - Scrape down the sides of the bowl with a spatula. Mix on speed 5 for 20 seconds until combined, if the mixture is too dry, add 1-2 Tbsp of whipping cream and mix until combined.19 - Transfer the mixture into a piping bag. Cut the end of the bag to give an opening of approx. 1.5-2 cm and fill each cannoli tube with the ricotta filling.20 - To finish, dust with icing sugar.Substitutions:Dry wine can be replaced with 120 ml of Marsala wineVegetable oil can be replaced with sunflower oilDark chocolate can be replaced with 200 g of chocolate chips